![]() I installed a more durable socket under the panel but before that I attached Velcro on the cable and scope to secure the plug. The 12 Volt Aux input plug is not made for frequent use and if it is what you use all the time, like me, it does wear out and results in reboots. I have experienced reboots like that and that were as a result of a bad Aux 12 Volt plug and connector. I don't think the the reset you did have anything to do with the problem, but give us some information on the "hypertune" you did ? what does that entail ? The Autostar 497 cannot be updated with a micro SD card I think the Autostar III in the LS is done that way. Same power supply, good connection as before. It stayed powered without issue before, but now, since I hit reset, it beeps, flashes me the auto star version for a few seconds then shuts off fully for half a second before repeating the cycle endlessly. As a result, I figured I would do a reset on the 497 hc before training drive and calibrating. So I finished up my hypertune, and spent probably 20 mins slewing around every which way checking its performance without issues. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |